
Panasonic FP0R series AFP0RF32CP PLC Programmable Logic Controller input 16, PNP output 16
Spec Detail
Item | Specifications |
---|---|
Product Number | AFP0RF32CP |
Part Number | AFP0RF32CP |
Performance specifications
Item | Specifications |
---|---|
Programming method / Control method | Relay symbol / Cyclic operation |
Number of I/O points : No expansion (Control unit only) | 32 points [Input : 16, Transistor output : 16] |
Number of I/O points : With expansion 1 Same type of control and expansion units | Max. 128 points (Note: For the limitations while operating units, reter to the manual.) |
Number of I/O points : With expansion 2 Mix type of relay and transistor units | Max. 128 points (Note: For the limitations while operating units, reter to the manual.) |
Program memory | EEPROM (no backup battery required) |
Program capacity | 32 k steps |
Number of instructions : Basic | 110 approx. |
Number of instructions : High-level | 210 approx. |
Operation speed : Up to 3,000 steps | Basic instructions : 0.08 μs min. Timer instructions : 2.2 μs min. High-level instructions : 0.32 μs (MV instruction) min. |
Operation speed : 3,001st and later steps | Basic instructions : 0.58 μs min. Timer instructions : 3.66 μs min. High-level instructions : 1.62 μs (MV instruction) min. |
Operation memory : Relay : Internal relay (R) | 4,096 points |
Operation memory : Relay : Timer / Counter (T / C) | 1,024 points |
Operation memory : Memory area : Data register (DT) | 32,765 words |
Operation memory : Memory area : Index register (IX, IY) | 14 words (IO to ID) |
Master control relay points (MCR) | 256 words |
Number of labels (JMP and LOOP) | 256 labels |
Differential points | Equivalent to the program capacity |
Number of step ladder | 1,000 stages |
Number of subroutines | 500 subroutines |
Special functions : High speed counter | Single-phase: 6 points (50 kHz max. each) 2-phase: 3 channels (15 kHz max. each) (Note: For the limitations while operating units, reter to the manual.) |
Special functions : Pulse output | 4 points (50 kHz max. each) 2 channels can be controlled individually. (Note: For the limitations while operating units, reter to the manual.) |
Special functions : PWM output | 4 points (6 Hz to 4.8 kHz) |
Special functions : Pulse catch input / interrupt input | Total 8 points (with high speed counter) |
Special functions : Interrupt program | Input : 8 programs (6 programs for C10 only) / Periodic : 1 program / Pulse match : 4 programs/td> |
Special functions : Periodical interrupt | In units of 0.5 ms : 0.5 ms to 1.5 sec. / In units of 10 ms : 10 ms to 30 sec. |
Special functions : Constant scan | In units of 0.5 ms : 0.5 ms to 600 ms |
Special functions : RS-232C port | One RS-232C port is mounted (3P terminal block) Transmission speed (Baud rate) : 2,400 to 115,200 bits/s, Transmission distance : 15 m 9.843 ft. Communication method : half duplex |
Maintenance : Memory backup : Program and system register | Stored program and system register in EEPROM |
Maintenance : Memory backup : Operation memory | Backup of the entire area by FeRAM (without the need for a battery) |
Maintenance : Self-diagnostic function | Watchdog timer (690 ms approx.), Program syntax check |
Maintenance : Real-time clock function | Not available |
Maintenance : Other functions | Rewriting in RUN mode, Download in RUN mode (incl. comments), 8-character password setting, and Program upload protection |
General specifications
Item | Specifications |
---|---|
Rated voltage | 24 V DC |
Operating voltage range | 20.4 to 28.8 V DC |
Allowed momentary power off time | 10 ms (20.4 V DC or higher) |
Operating temperature | 0 to +55 ℃ 32 to +131 ℉ |
Storage temperature | -40 to +70 ℃ -40 to +158 ℉ (-20 ℃ to +70 ℃ -4 to +158 ℉ for T32 only) |
Operating humidity | 10 to 95% RH (at 25 ℃ 77 ℉, no condensation) |
Storage humidity | 10 to 95% RH (at 25 ℃ 77 ℉, no condensation) |
Breakdown voltage (Detection current: 5 mA) | Input terminals - output terminals, Output terminals - power and
functional ground terminals --- Transistor output : 500 V AC for 1
minute (Relay output : 1,500 V AC for 1 minute) / Input terminals - power and functional ground terminals, Functional ground terminal - power terminal --- Transistor output : 500 V AC for 1 minute (Relay output : 500 V AC for 1 minute) / Output terminals - output terminals (different common terminals) --- Relay output : 1,500 V AC for 1 minute |
Insulation resistance (Test voltage: 500 V DC) | Input terminals - output terminals, input terminals - power and
functional ground terminals, output terminals - power and
functional ground terminals, functional ground terminal - power
terminal --- Transistor output : 100 MΩ minimum (relay output : 100
MΩ minimum) / Output terminals - output terminals (different common terminals) --- Relay output : 100 MΩ minimum |
Vibration resistance | 5 to 9 Hz, single amplitude of 3.5 mm, 1 sweep/min; 9 to 150 Hz, constant acceleration of 9.8 m/s2, 1 sweep/min; for 10 min each in X, Y, and Z directions |
Shock resistance | 147 m/s2 or more , 4 times each in X, Y, and Z directions |
Noise immunity | 1,000 V (p-p) with pulse widths 50 ns and 1 μs (using a noise simulator)(Power supply terminal) |
Operating environment | Free from corrosive gasses and excessive dust |
Input specifications
Item | Specifications |
---|---|
Rated input voltage | 24 V DC |
Applied voltage range | 21.6 to 26.4 V DC |
Rated input current | 2.6 mA approx. (at 24 V DC) |
Input impedance | 9.1 kΩ approx. |
Input points per common | 16 points / common |
Min. ON voltage/Min. ON current | 19.2 V / 2 mA |
Max. OFF voltage/Max. OFF current | 2.4 V / 1.2 mA |
Response time : OFF→ON | 20 μs or less * An input time constant (0.1 to 64 ms) can be set. |
Response time : ON→OFF | Same as above |
Insulation method | Photocoupler |
Remark | Since the response time of X0 to X7 is very fast (for high-speed counter input) the FP0 happens to chattering noise as an input signal. To prevent this, it is recommended that the timer should be put in the ladder program. |
The following are some of the drive models, both new and used are
stocked:
MSDA3A3A1A | MSDA5A3A1A | MSDA013A1A |
MSDA023A1A | MSDA043A1A | MSDA083A1A |
MDDA103A1A | MDDA153A1A | MDDA203A1A |
MDDA253A1A | MDDA303A1A | MDDA353A1A |
MSDA403A1A | MSDA503A1A | MSD023A1XXV |
MSDA083A1XXV | MSD043A1X | MSDA043D1A |
MQDA043A1A | MUDS043A1A | MUDS023A1A |
MUDS083A1A | MUMS082A1E0S | MUDS083A1M |
MUMA012P1T | MUMA022P1T | MUMA042P1T |
MUMA042P1S | MUMA012P1S | MUMA022P1S |
MUMS082P1S | MSDA043A1XXV | MSDA013A1XXV |
MKDET1505P | MLDET2310P | MUMA082P1T |
MLDET2510P | MKDET1310P | MUMS042A1AOS |
MSM041A211 | MQMA042A1E | MSMA022P1A |
MSM042P1B | MSM042AJB | MSM011P1N |
MQMA022S2P | MSM012AJA | MSM012P1F |
MDMA152S1C | MSM042AJA | MQMA012C2P |
MSMA022A1B | MSM021DJE | MSD043A1X |
MSD043A1XX | MSM042A1A | MSM5AZA1B |
MUMS012C2U1S | MUMS012A1F0S | MSMZ082A1B |
MSD013A1XX | MSM012A1A | MSMA012C1A |
MSDA013D1A | MSMA5AZS1A | MQMA012P1B |
MSMD042P1T | MUMS022A1B0S | MFM082A1C |
MQMA042A1E | MSMA022C1A | MSMA022C1E |
Our advantage Products:
【Honeywell】Module DCS / PLC
【Emerson】DeltaV Module / Servo Motor
【ABB】Input Output Module
【AB】Module / Touch Screen
【Rosemount】Pressure and Temperature Transmitter
【Yokogawa】Pressure Transmitter
【Yaskawa】Servo Drive / Servo Motor
【Mitsubishi】Servo Drive / Servo Motor
【GE】IC69 Series PLC/ Fanuc Servo Motor and Drive
(Modicon,SMC,SICK,NORGREN,Siemens etc.)
Shenzhen Wisdomlong Technology CO.,LTD
Contact person:Suki
Email:wtl2502keji@163.com
Skype:wtl2502
Company website:www.wtltian.com
Tel:+86-13268302140
Shenzhen Wisdomlong Technology CO.,LTD
Shenzhen Wisdomlong Technology CO.,LTD Mainly engaged in automation parts, PLCS,DCS,sensors, relays,
dirves,encoder, servo drive,soft starter,touch
screen,instrument,process control,electric transmission and factory
automation aspects of the project design,software
programming,technical service and staff training. Our company
locats at the central of China,Shenzhen, Guangdong Province. With
rapid development, Wisdomlong serves fields of automation in global
markets, Our business covers five continents throughout the world
with the basic conviction of honest, the international management
of customer-centered concept and purpose of bringing convenience to
customers. We have confidence to bring our customers more
substantial profit with high-quality service and reasonable prices.
Choosing us,you will choose a sincere friend and reliable partner.
Please feel free to contact us if you are a global manufacturer of
high quality brand products who desires to enter the Chinese market
or who searches for a Chinese agent.We would like to create a
brilliant future with friends in domestic and overseas. All goods
sold have one year warranty.
The company with domestic and international numerous well-known
brands supplier to build have extremely good relations of
cooperation, in Japan, South Korea, southeast Asia, Africa, Europe
and the United States, and formed a stable and efficient supply
network. The agent and the products are widely used in machinery,
equipment manufacturing, electric power, metallurgy, petrochemical,
automobile manufacturing industry, paper making, chemical industry,
medicine and aerospace industries.
Our Main Brand:
MITSUBISHI
YASKAWA
PANASONIC
GE FANUC
EMERSON
FISHER-ROSEMOUNT
HONEYWEL
ABB
AB
SHNEIDER MODICON
SIEMENS
................